Tandberg Codian HD MCU 4500 Series Bedienungsanleitung Seite 1

Codian HD MCU MCU 4500 SeriesGetting started

6 To configure Ethernet Port A, enter the following for auto-sensing mode: ethertype autoor to configure a speed and duplex, use the following comman

Configuring the MCU7Configuring the MCUStep one: Log in to the MCUAll administration of the MCU is performed via the web interface.To log in to the we

8Step three: Add endpoints (optional)One way to add participants to a conference that you create is to have the MCU automatically call them when the c

Using the MCU9Using the MCUCreating conferencesTo create a conference:1 In the web interface of the MCU, go to Conferences and click Add new conferenc

10Calling participants in to a conferenceTo call participants in to a conference:1 In the web interface of the MCU, go to Conferences and click on the

Using the MCU11Streaming conferencesStreaming is a way of viewing a conference in a standard web browser. The MCU allows streaming of video and, if en

12Instructing conference participantsYou need to tell conference participants how to join conferences. You can also tell them how to use the Far-End C

Troubleshooting and technical support information13Troubleshooting and technical support informationUsing the event log to help solve a problemUnless

14Technical specificationsPower requirementsOver-current protectionEnsure the supply to this unit is protected by a branch circuit protector rated by

61-0011-05

Codian MCUMCU 4500 SeriesGetting started

Copyright © Codian 2008. All rights reserved. This Getting Started Guide may not be copied, photocopied, translated, reproduced, or converted into any

Table of contentsGeneral information ...

General information1General informationAbout the Multipoint Control Unit (MCU)The MCU 4500 Series is a range of technologically advanced and powerful

2LED behaviorTable 1 describes the behavior of the LEDs.Table 1: MCU LED behaviorLED Color IndicatesCompact Flash Activity Flashing greenOne of: the

LED behavior3Ethernet Port Status, for each Ethernet port :FDX Green The link has been negotiated as a full-duplex linkAct Green Packets are being tra

4Connecting the MCUBefore you startStep one: Connect powerConnect the power connector on the rear of the unit to the power supply using the supplied p

Initial configuration5Initial configurationStep one: Connect to the console port1 Ensure power is connected to the MCU and the Status LED is green.2 C